D
DerrtyOne
Neues Mitglied
- Dabei seit
- 23 Sep 2011
- Beiträge
- 1
- Reaktionen
- 0
Hallo zusammen,
Ich wollte meinen Controller ein Firmware Update gönnen.
Hab mich strickt an folgender Anleitung gehalten bis punkt 5.
Leider führt er kein Update durch und ich komme nicht mehr aus dem Update Modus raus. Controller wird nur noch als Flash Laufwerk erkannt =(
Hoffe hier weiß jemand weiter =)
Beste Grüße Stefan
Uploading the DN-SC2000 System Software
1. You should have already downloaded and unzipped the update file from denondj.com to your “Desktop”.
2. Connect the USB cable to the USB port of your computer
3. Disconnect the USB cable from the side of the controller
4. While pressing the following (3) keys [SHIFT]+[PREVIOUS]+[NEXT], connect the USB cable to
DN-SC2000 (see fig 1)
For Windows users, “New Hardware Found – DN-SC2000” will balloon from the lower task bar area,
and shortly after that, an empty popup window will appear as a Hard Drive on your desktop named,
“DN-SC2000”.
5. Drag & Drop the included DN-SC2000_v1.25.bin file into the white empty window area. At this point,
please wait about 10 seconds for the update to complete.
*Do not drag and drop the entire .zip file into the device, you must unzip it first.
Note:
For MAC users, you may see a Warning
Dialog when completed, just close and disregard.
6. After updating successfully, DN-SC2000 will switch back to Midi Controller mode automatically
and will be ready to use.
Enjoy your new updates!
Ich wollte meinen Controller ein Firmware Update gönnen.
Hab mich strickt an folgender Anleitung gehalten bis punkt 5.
Leider führt er kein Update durch und ich komme nicht mehr aus dem Update Modus raus. Controller wird nur noch als Flash Laufwerk erkannt =(
Hoffe hier weiß jemand weiter =)
Beste Grüße Stefan
Uploading the DN-SC2000 System Software
1. You should have already downloaded and unzipped the update file from denondj.com to your “Desktop”.
2. Connect the USB cable to the USB port of your computer
3. Disconnect the USB cable from the side of the controller
4. While pressing the following (3) keys [SHIFT]+[PREVIOUS]+[NEXT], connect the USB cable to
DN-SC2000 (see fig 1)
For Windows users, “New Hardware Found – DN-SC2000” will balloon from the lower task bar area,
and shortly after that, an empty popup window will appear as a Hard Drive on your desktop named,
“DN-SC2000”.
5. Drag & Drop the included DN-SC2000_v1.25.bin file into the white empty window area. At this point,
please wait about 10 seconds for the update to complete.
*Do not drag and drop the entire .zip file into the device, you must unzip it first.
Note:
For MAC users, you may see a Warning
Dialog when completed, just close and disregard.
6. After updating successfully, DN-SC2000 will switch back to Midi Controller mode automatically
and will be ready to use.
Enjoy your new updates!
